Table of Contents

Manus Et Machina

Engineering Design Studio (A5, 015)
Sunday, October 08, 2017, 9:00 am – 11:40 am


Prelude

—-

Essay 1 presentations

Student 3 Kristopher A Future with LIGO
Student 4 Grace An Evaluation of SpaceVR’s VR Enabled Robots
Student 5 Al Reem Solar Filter

Update on Box SetUp

Barkin solved the problem: It was a mix of software and hardware issues. Firstly, the duration of the signal was to short – the delay should be ±1000 millis. The pins have to be changed from 1&2 to 2&3 because 0&1 are the serial connection pins of the Arduino (TX for sending commands, RX for receiving commands). Secondly, some of the wires were dead and they weren't conducting electricity. Barkin changed all of them!

Lastly, the majority added the resistor in the following way which caused some problems:

The best way to connect the resistor is as in the button example we used a few weeks ago. See picture below:

Please thank Barkin for checking and updating the code! Download it from The Box Code Site.


Concept presentation

What happened since last Sunday? Remember there are ONLY 9.5 weeks to go!!